Please login or register


Please email the Administrator if you cannot login admin@boholairsoft.com


You are not connected. Please login or register

View previous topic View next topic Go down  Message [Page 1 of 1]

1 molds on your switch assembly - corroded on Tue Jun 22, 2010 11:06 pm

maomag


 
 
since it's been months that your AEG's been used as a wall hanger/decor or some even put it in lolo's cavan...it's time to clean-up your AEG's switch assembly.

you might encounter lost of electric/current while playing which you think the battery is the cause...before you suspect your batt, have you clean or tune-up your switch assemble? for sure it's corroded, time to buy a contact cleaner or the cheapest alternative is a clean sandpaper...

after you tune-up & clean your aeg's it's now time to recycle your batts...simple as discharged it using a 12v bulb & then charged it...twice will be fine!!!

2 Re: molds on your switch assembly - corroded on Thu Jun 24, 2010 11:07 pm

Mr.Lee


 
 
up ni nako papa

ako gamit sa ako mga contact points is metal polish... dba murag bago ang agi...

labi na sa PB,Switch assymbly,motor,contact pins from bat to aeg...

samot na ky nag batmot na akoa sig

3 Re: molds on your switch assembly - corroded on Thu Jun 24, 2010 11:10 pm

maomag


 
 
pwede ra ng metal polish ilimpyo pero kiskisan gihapon nimo ug sandpaper kay ang metal polish kay mo coat man na siya ug wax so naay chance dli mocontact


_________________
Dugong Bol-anon!!![embed-flash(width,height)]

Sponsored content


View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum